swingarm spools

[Cage]

since nobody decided to show up to work today, think I am going to run a bunch of swingarm spools in one of the lathes. Anyone got a spacing differetial between a stand and the bike so I can get a good idea of how long to make them.

Here's a couple pics of the first ones I made for myself, please excuse the shitty bolts, it's all I had.

http://i192.photobucket.com/albums/z266/cage1dane/SwingarmStandSpools002.jpg
http://i192.photobucket.com/albums/z266/cage1dane/SwingarmStandSpools003.jpg
http://i192.photobucket.com/albums/z266/cage1dane/SwingarmStandSpools004.jpg
http://i192.photobucket.com/albums/z266/cage1dane/SwingarmStandSpools001.jpg

[jjkGURU]

too bad ya didn't know in advance - i have an extra set laying around that you couldda copied

[Cage]

too bad ya didn't know in advance - i have an extra set laying around that you couldda copied
think I may just make them in varying lengths, that way everyone would be covered. Not sure how it is with other brands, but the Hondas tend to break off in a crash. Might have to throw a bunch in the "trunk" of my bike and hand them out when people need them.

[Luckystrike]

Where in K'zoo do you work?

[Cage]

Where in K'zoo do you work?
FEMA corp. it's on Vanderbilt between Shaver and Oakland. And if my boss reads this from home.....just kidding dude, I've been working hard all day.

[jjkGURU]

FEMA corp. it's on Vanderbilt between Shaver and Oakland. And if my boss reads this from home.....just kidding dude, I've been working hard all day.

:laughing::laughing::laughing: